I'm repairing a seized piston in a Kohler RH265 engine used on a Benchmark 38247 tiller made by Ardisam. I got the governor-throttle linkage hooked up fine, but had a linkage left over that I couldn't figure out where it went.
After checking with Roger at Hamelin's in North Bay it turns out Kohler uses a 3-position throttle lever. The first position, Start, closes the choke by pushing the choke linkage into it. The idle and run positions allow the choke spring to open the choke.
I usually take photographs as I disassemble a motor but failed to do on this part. I caused myself a lot of frustration, but Roger got me going again.
No comments:
Post a Comment